![]() If the network type of the interface is NBMA, when the interface type is changed to broadcast, neighbor relationships do not need to be configured. In the broadcast network, if there is a device that does not support multicast address, you can change the network type of the interface to NBMA. When link layer protocols remain unchanged, you can change network types and configure OSPF features to flexibly build networks. An OSPF neighbor relationship can be established only when the results on the two ends are the same. Specifically, OSPF performs an AND operation on the local subnet mask and the local IP address, and on the local subnet mask and the remote IP address. ![]() By default, if peer-ip-ignore is not specified in the command, OSPF checks the network segment of the two ends during which an OSPF neighbor relationship is to be established. ![]() Indicates that the network type of the interface is changed to point-to-point.ĭisables network segment check when IP address unnumbered is not configured for a P2P interface changed from a broadcast interface and the interface tries to establish an OSPF neighbor relationship. Indicates that the network type of the interface is changed to point-to-multipoint. ![]() Indicates that the network type of the interface is changed to NBMA. Indicates that the network type of the interface is changed to broadcast. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |